Hydraulic
beam mould
Hydraulic
beam mould
Hydraulic
beam mould
Hydraulic
beam mould

Hydraulic beam mould

Hydraulically-controlled beam moulds provide you with a variable basic construction for manufacturing high quality concrete elements. In this context, standard or special profiles with different heights can be produced, as I, T or TT cross-sections, and also convertible to rectangular cross-section or V purlin. Specified abutments are required for especially large span widths with up to 1,000 t tension.

The beam heights of 900 - 2,600 mm are continuously adjustable, along with the upper cord widths of up to 900 mm. Depending on the configuration of the beam, a lower cord is integrated, for which no tensioning is required. The web width is defined by the width of the bottom.

The configuration can be completed in almost any dimension according to your individual requirements. With an additional pre-stressing unit, it is possible to produce pre-stressed concrete elements. In this context adutments are installed at the front end in the factory floor, which direct the tensioning force into the ground. More than 1,000 t can be applied to the tension wires using hydraulic cylinders. High frequency vibration technology and a heating register with insulation for a homogeneous heat distribution can be installed if required.

Numerous basic variants for maximum flexibility

The construction with bottom formwork, grid, telescopic supports and upper and lower cord is designed so that numerous concrete elements can be manufactured exceptionally cost effective:

  • Bottom formwork in steel or ply-wood configuration, that can be exchanged rapidly as required
  • Design of upper and lower cord freely selectable
  • Prefabricated haunch inserts for a visually appealing and cost effective column support
  • Design of upper and lower cords in connection with the side surface for an optimum exposed concrete surface
  • Flexible change of frames: from gable roof beams, parallel beams to bridge beams, easy and rapid to convert without use of an indoor crane
  • Attachable scaffolding can be integrated as required

Simple stripping and casing for optimum process flows

Hydraulic beam moulds primarily stand out thanks to their very simple stripping and casing, the wide range of haunch versions and frame changes. Beam heights of up to 1,600 mm are possible without overhead stressing.

Moreover the hydraulic beam mould is also available in a duplex version which substantially increases the plant productivity.

Simple and mechanical – the Yellow Line

The mechanical movable mould enables an unhindered reinforcement-work as access is available from any side. Beam height and slope can be adjusted easily with winches and a few hand movements.

At the same time the tension wires can be taken full advantage of, as several beams can be manufactured after each other in one tensioning line.

Your contact

Alexander  Kaspar

Senior Sales Manager

Telephone: +49 7134 52 460

E-Mail: alexander.kasparvollert.de