Hydraulically-controlled beam moulds provide you with a variable basic construction for manufacturing high quality concrete elements. In this context, standard or special profiles with different heights can be produced, as I, T or TT cross-sections, and also convertible to rectangular cross-section or V purlin. Specified abutments are required for especially large span widths with up to 1,000 t tension.

The beam heights of 900 - 2,600 mm are continuously adjustable, along with the upper cord widths of up to 900 mm. Depending on the configuration of the beam, a lower cord is integrated, for which no tensioning is required. The web width is defined by the width of the bottom.

The configuration can be completed in almost any dimension according to your individual requirements. With an additional pre-stressing unit, it is possible to produce pre-stressed concrete elements. In this context adutments are installed at the front end in the factory floor, which direct the tensioning force into the ground. More than 1,000 t can be applied to the tension wires using hydraulic cylinders. High frequency vibration technology and a heating register with insulation for a homogeneous heat distribution can be installed if required.